Thread refresh

@whitequark@mastodon.social
✧✦Catherine✦✧ @whitequark@mastodon.social
#1 public
replies: #2

today in "draw the rest of the fucking owl"

Establish BGP session and configure routing To use the anycast addresses, you need to establish a BGP session. A specific node can be connected to a single AnycastIP router (IPv4 and IPv6 session) at a given time. You can have multiple nodes per region - all our routers support ECMP. [1. Install desired routing software (for example, FRRouting, BIRD, Quagga, ExaBGP etc.)] 2. Get the IP addresses of our router in the given region (see below) and configure BGP sessions using the following details
reply (1)
@whitequark@mastodon.social
✧✦Catherine✦✧ @whitequark@mastodon.social
#2 public
in reply to #1 - replies: #3

chat what's your fave BGP software

reply (11)
@jpm@aus.social
Joel Michael @jpm@aus.social
#3 public
in reply to #2 - replies: #4

@whitequark FRR and Quagga are forks of the same thing, both are kinda-sorta a bit like Cisco IOS (derogatory). BIRD is lightweight in comparison, but its config is horrible and the documentation sucks.

reply (2)
@jpm@aus.social
Joel Michael @jpm@aus.social
#4 public
in reply to #3 - replies: #5

@whitequark and in either case, if you’re running BGP without BFD, you’re going to have a Very Bad Time during link failures

reply
@whitequark@mastodon.social
✧✦Catherine✦✧ @whitequark@mastodon.social
#5 public
in reply to #4

@jpm i just want Rage4 AnycastIP

reply